5.On the Features page, select the features you want to install. If additional functionality is required to install a feature you selected, you’ll see an additional dialog box. Tap or click Add Features to close the dialog box and add the required features to the server installation. When you are ready to continue, tap or click Next. Depending on the added feature, there might be additional steps before you get to the Confirm page.. You also can use this technique to check capacity, status, logical sector size, physical sector size, provisioned space size, thin provisioning alert threshold, and total used space. By default, Storage Space alerts you when storage is approaching capacity and when a storage space reaches 70 percent of the total provisioned size. When you get such an alert, you should consider allocating additional storage.. After you create a storage pool, you can allocate space from the pool to virtual disks that are available to your servers. Each physical disk allocated to the pool can be handled in one of three ways:. Objects and object managers. As an administrator, you can take ownership of objects on the network to ensure that you can’t be locked out of files, folders, printers, and other resources. After you take ownership of files, however, you can’t return ownership to the original owner (in most cases). This prevents administrators from accessing files and then trying to hide the fact.. Sound security practices and settings are essential to successful system administration. Two key methods to configure security settings are to use security templates and security policies. Both of these features manage system settings that you would otherwise manage through Group Policy.. NOTEWhen the local DHCP server is also a Network Policy Server, the Network Policy Server should always be reachable. If you haven’t configured the server as a Network Policy Server or the DhCP server is unable to contact the designated Network Policy
Server, you’ll get an error stating this on the Network Access Protection tab.. 2.Enter a name for the superscope, and then tap or click Next.. 14.Configure default WINS settings for the DHCP clients. The techniques you use are the same as those previously described. Tap or click Next.. 4.On the Create A New Failover Relationship page, shown in Figure 8-11, use the Mode list to set the failover mode as Load Balance or Hot Standby.. Subdomains are often referred to aschild domains. For example, the fully qualified domain name (FQDN) for a computer within a human resources group could be designated as jacob.hr.microsoft.com. Here,jacobis the host name,hris the child domain, andmicrosoft.comis the parent domain.. With full integration, DNS information is stored directly in Active Directory, which enables you to take advantage of Active Directory’s capabilities.. To enable DNS on the network, you need to configure DNS clients and servers. When you configure DNS clients, you tell the clients the IP addresses of DNS servers on the network. By using these addresses, clients can communicate with DNS servers anywhere on the network, even if the servers are on different subnets.. FIGURE 9–1Use the DNS Manager console to manage DNS servers on the network.. ? Internet PrintingCreates a website where authorized users can manage print jobs on the server. It also lets users who have Internet Printing Client installed to connect and print to shared printers on the server by using the Internet Printing Protocol (IPP). The default Internet address for Internet Printing is http://ServerName/Printers, whereServerNameis a placeholder for the internal or external server name, such as http://PrintServer15/Printers or http://www.cpandl.com/Printers..