Physical drives. You also can use this technique to check allocated size, status, provisioned size, provision type, redundancy type, and more.. NOTEIf you try to change the letter of a drive that’s in use, Windows Server 2012 R2 displays a warning. You need to exit programs that are using the drive and try again, or allow Disk Management to force the change by tapping or clicking Yes when prompted.. CAUTIONBefore you try to extend a volume, be aware of several limitations. First, you can extend simple and spanned volumes only if they are formatted and the file system is NTFS. You can’t extend striped volumes, volumes that aren’t formatted, or volumes that are formatted with FAT. Additionally, you can’t extend a system or boot volume, regardless of its configuration.. ? No Files Or Programs From The Shared Folder Are Available OfflineSelect this option if you don’t want cached copies of the files and programs in the share to be available on client computers for offline use.. The basic permissions are created by combining special permissions in logical groups. Table 4–3 shows special permissions used to create the basic permissions for files. By using advanced permission settings, you can assign these special permissions individually, if necessary. As you study the special permissions, keep the following in mind:. 1.In Active Directory Users And Computers, ensure that Advanced Features is selected on the View menu, and then access the container for the object.. ? EnterpriseThrough Group Policy that applies to a site, a domain, or an organizational unit, you can enable disk quotas for groups of users and computers.. 6.Wait for the snap-in to complete the analysis of the template. If an error occurs during the analysis, you can view the error log by pressing and holding or right-clicking the Security Configuration And Analysis node and choosing View Log File.. When you are working with the Security Configuration And Analysis snap-in, you can review the differences between the template settings and the current computer settings. As Figure 5–9 shows, the template settings stored in the analysis database are listed in the Database Setting column, and the current computer settings are listed in the Computer Setting column. If a setting has not been analyzed, it is listed as Not Defined.. 9.If you want to activate the scope, select Yes, and then tap or click Next. Otherwise, select No, and then tap or click Next.. 7.Tap or click Add to create the address reservation. Repeat this step to add other address reservations.. ?Load all zones that are stored in files rather than in AD DS.. 3.For Zone Type, select Secondary Zone. Tap or click Next.. 2.Restart the domain controller server, and enter safe mode..